Builders description
Charlie's Tuna Specifications:
General:
Year Built: 1999
Owner/Builder: Charles S. Breen
Specification Hull:
LOA: 62' 0"
LWL: 51' 0"
Beam: 16' 4"
Draft: 4' 0"
Displacement: 52,000 lbs (Dry)
Fuel Capacity: 1500 gal.
Hull Plating: .25" 5058 aluminum
Keel: .5"x 6" 6061 aluminum
Ribs: .5"x 4" 6061 aluminum (24" oc)
Stringers: .5" x 1.5" 6061 aluminum (12" oc)
Transom: .5" 5058 aluminum
Engine Beds: 3.5"x 8" x .375" 6061 aluminum
Dead Rise: 19 degrees
Chines: Single 8" hard
Welding: All seams, triple TIG welded outside, Triple MIG welded inside with matched hull alloy.
Specification Running Gear:
Engines: Twin Lugger-L6140AL2.3, 6 cylinder diesels, 700hp @ 2100 rpm (each) Serial Number: Port: 1401-2567, Stb. 1401-2568
Engine Hours: Port: less then 400 Stb.: less then 400
Transmission: Twin Disk Model: MG5114IV 1.8:1, 14 degree dn. angle; Serial No.: Port: TBD Stb.: TBD
Shafts: 2.75"
Shaft Seals: PSS Dripless
Shaft Struts: 1.75 SS316 with 2.75x10" Cuttlas Bearings
Propellers: 30x34" 5 Blade, Katapult
Rope Cutter: Shaft Shark SS700 (2.75")
Performance: 28 knots WOT at 2100rpm (600 gal fuel load)
Fuel Consumption: 26 gph per engine at WOT
Rudder Shafts: 2.5" SS316 with dual cuttlas support and O-Ring seal.
Rudders: Foil Shaped welded SS316 30"x14"
Thru Hull fittings: Marelon, reinforced poly-carbonate